Product Description

Latapoxy SP 100 is a stainless, pigment free, colour fast epoxy grout for grouting wall and floor installation of ceramics tile, brick and stone. It is supplied as a factory proportioned kit consisting of epoxy resins, hardener and silica filler, Latapoxy SP100 cleans with water while fresh, and can be used on floors and walls in interior or exterior applications of residential or commercial constructions.

Advantages

• It deals in new construction as well as for renovation.
• It is highly resistant to heavy traffic and rough usage.
• It cures at low temperature.
• Easy to clean with water when fresh, even on textured tiles.
• It is useful in active food preparation areas such as kitchen.
• It has superior stain resistance.
• It is easy to install and provides a finish as beautiful and durable as the tile itself.
• It is normally recommended where stain and chemical resistance are required.
• Kitchens, Cafeterias, Residential, Counter tops, Floors, Wall, Bathroom and Swimming pools.
• It is non-flammable, easy to maintain and durable.

Key Features

• The grout is 100% epoxy and contain no water – soluble material, which could lead to effloresce or molting.
• The grout never needs sealing and is dense and durable as the tile itself.
• The colour is already locked into the filler and cannot be washed away be use of excess water or aggressive scrubbing when cleaning.

Installation

• Surface preparation Before starting to grout remove spacers and debris in grout joints and remove dust and dirt using a wet sponge. Do not leave water standing in joints. Room temperature must be between 90of (32oC).

• Mixing Pour Latapoxy ® SP-100 Part A and Part B into clean mixing pail and mix thoroughly by hand until liquids are completely blended. Add LATAPOXY® SP-100 Part C powder and mix until uniformly blended.

• Application Immediately pour entire contents of pail onto a flat surface (don’t leave in pail ). Spread with a sharp, firm rubber grout float. Work the grout paste into the joints until completely filled. Use diagonal stroke to pack the joints. Insure that joint is filled and grout is not just sitting on top (i.e. bridging the joint”).

• Cleaning Remove excess grout from the face of the tiles with the edge of the grout float. Hold the float at a 90o angle and pull it at a 45o angle diagonally across the joints and tile to avoid pulling out the material. Clean using a white nylon pad and plenty of cool clean water.

back to top